描述
汽车转向传感器齿轮级PA12芯片
PA12塑料材料
良好的抗冲击性机器化学稳定性
良好的耐磨性、自润滑性和耐溶剂性
免费样品和快递
汽车转向传感器齿轮级PA12芯片
产品详细信息
汽车转向传感器齿轮级PA12芯片
1。尼龙加工注意事项
最好不要超过三次，以避免产品变色或机械和物理性能急剧下降。施用量应控制在25%以下。过多会导致工艺条件波动。回收材料和新材料必须混合干燥
2。安全说明
打开尼龙树脂时，应先打开喷嘴温度，然后加热进料筒。当喷嘴堵塞时，喷嘴不应面对，以防止气缸中的熔体因压力累积而突然释放，这是危险的
3。使用脱模剂
使用少量脱模剂有时可以改善和消除气泡等缺陷。尼龙制品的脱模剂可以从硬脂酸锌、白油等中选择，也可以混合成糊状。使用时，它必须小且均匀，以避免表面缺陷
4。机器停机时清空螺钉，以防下次生产时螺钉断裂
尼龙产品后处理尼龙产品后处理是为了防止和消除产品中的残余应力或吸湿引起的尺寸变化
Automotive Steering Sensor Gear Grade PA12 Chips
.
PA12 Plastic Material
Good impact resistance machine chemical stability
Good wear resistance, self-lubricating and solvent resistance
Free Sample and express delivery
Automotive Steering Sensor Gear Grade PA12 Chips
Product Details
Automotive steering sensor gear Grade PA12 Chips
1.Precautions for nylon processing
It is better not to exceed three times in order to avoid discoloration of the product or a sharp drop in mechanical and physical properties. The application amount should be controlled below 25%. Too much will cause fluctuations in process conditions. Recycled and new materials must be mixed for drying.
2. Safety instructions
When the nylon resin is turned on, the nozzle temperature should be turned on first, and then the feed cylinder should be heated. When the nozzle is blocked, the nozzle should not be faced to prevent the melt in the cylinder from being suddenly released due to pressure accumulation, which is dangerous.
3. Use of release agent
The use of a small amount of release agent can sometimes improve and eliminate defects such as bubbles. The release agent for nylon products can be selected from zinc stearate and white oil, etc., and can also be mixed into a paste. When used, it must be small and uniform to avoid surface defects.
4. Empty the screw when the machine is stopped to prevent the screw from being broken during the next production.
Nylon product post-processing Nylon product post-processing is to prevent and eliminate residual stress in the product or dimensional changes caused by moisture absorption.
评价
目前还没有评价